148
Drive Chain Lubrication
Lubrication is necessary every 200 miles
(300 km) and also after riding in wet
weather, on wet roads, or any time that
the chain appears dry.
To lubricate the drive chain:
• Use the special chain lubricant as
recommended in the Specifications
section.
• Apply lubricant to the sides of the
rollers then allow the motorcycle to
stand unused for at least eight
hours (overnight is ideal). This will
allow the oil to penetrate to the
chain O-rings etc.
• Before riding, wipe off any excess
oil.
• If the chain is especially dirty, clean
first and then apply oil as
mentioned above.
Caution
Do not use a pressure washer to clean
the chain as this may cause damage to
the chain components.
Drive Chain Free Movement
Inspection
Warning
Before starting work, make sure that
the motorcycle is stabilized and
adequately supported.
This will help prevent injury personal
injury and/or damage to the
motorcycle.
1. Maximum movement position
To inspect the drive chain free
movement:
• Place the motorcycle on a level
surface and hold it in an upright
position with no weight on it.
• Rotate the rear wheel by pushing
the motorcycle to find the position
where the drive chain is tightest,
and measure the vertical
movement of the drive chain
midway between the sprockets.
To Next Page
Loading...
