Triumph Trident - Page 52

GENERAL INFORMATION
52
Bike Setup - Indicators
The turn signals can be set to Auto
Basic, Auto Advanced or Manual mode.
Auto Basic
Auto Advanced
Manual
Selecting a Turn Signals Mode
To select the required turn signals
mode:
▼ From the Bike Setup menu, press the
Up and Down buttons to select
Indicators.
▼ Press the Right button to view the
available options.
▼ Press the Up and Down buttons to
scroll between the following options:
– Auto Basic - The self-canceling
function is on. The turn signals
will activate for eight seconds and
an additional 71yards (65 meters).
– Auto Advanced - The self-
canceling function is on. A short
press activates the turn signals
for three flashes. A longer press
activates the turn signals for
eight seconds and an additional
71yards (65 meters).
– Manual - The self-canceling
function is off. The turn signals
must be manually canceled using
the turn signal switch.
▼ Press the Select button to confirm
the required selection. A tick is
shown to indicate the selected
option.
Bike Setup - TC
The Traction Control (TC) system can be
temporarily disabled. The Traction
Control (TC) system cannot be
permanently disabled, it will be
automatically enabled when the ignition
is turned off and then on again.
Enabled
Disabled
To disable or enable the TC system:
▼ From the Bike Setup menu, press the
Up and Down buttons to select TC.
▼ Press the Right button to view the
available options.
▼ Press the Up and Down buttons to
scroll between Enabled and Disabled.
▼ Press the Select button to confirm
the required selection. A tick is
shown to indicate the selected
option.