GENERAL INFORMATION
33
High Beam Button
When the high beam button is pressed
the high beam will be switched on. Each
press of the button will swap between
dip and high beam.
The headlight will function when the
ignition switch is turned to the ON
position. The headlight will go off while
pressing the starter button until the
engine starts.
A lighting on/off switch is not installed
on this model. The position light, tail
light and license plate light all function
automatically when the ignition is
turned to the ON position.
A Pass feature is not available on this
model.
Throttle Control
An electronic throttle twist grip controls
the opening and closing of the throttles
via the engine’s electronic control
module. There are no direct-acting
cables in the system.
The throttle grip has a resistive feel to it
as it is rolled rearwards to open the
throttles. When the grip is released it
will return to the throttle closed position
by its internal return spring and the
throttles will close.
There are no user adjustments for the
throttle control.
1. Throttle closed position
Warning
Reduce speed and do not continue to
ride for longer than is necessary with
the Malfunction Indicator Light (MIL)
illuminated.
The fault may adversely affect engine
performance, exhaust emissions and
fuel consumption.
Reduced engine performance could
cause a dangerous riding condition,
leading to loss of control and an
accident. Contact an authorized
Triumph dealer as soon as possible to
have the fault checked and rectified.
To Next Page
Loading...
Need help?
General
