What to do if my Trividia Blood Glucose Meter shows a 'Hi' or 'Lo' reading?
If your Trividia Blood Glucose Meter displays a warning for out-of-range high results (greater than 600 mg/dL) or out-of-range low results (less than 20 mg/dL), retest using a new test strip. If the result is still “Hi” or “Lo,” it is important to contact your doctor immediately.
Why isn't my Trividia Blood Glucose Meter beeping or starting after I apply the sample?
If, after applying a sample to the Trividia Blood Glucose Meter, the test doesn't start, and the meter doesn't beep or begin testing, consider the following: * The sample drop might be too small. In this case, repeat the test with a new test strip and a larger sample drop. * The sample might have been applied after the two-minute shut-off. Repeat the test with a new test strip, ensuring you apply the sample within 2 minutes of inserting the test strip into the meter. * There could be a problem with the test strip. Try repeating the test with a new test strip. If testing still hasn't begun, it may indicate a problem with the meter.
How to fix an operating temperature error on my Trividia Blood Glucose Meter?
If your Trividia Blood Glucose Meter displays an Operating Temperature Error, it means the meter is outside the correct testing temperature range. Move the meter and test strips to an area between 57°F and 104°F. Then, wait 10 minutes before testing again.
What does 'Sample Error' mean on my Trividia Blood Glucose Meter?
If your Trividia Blood Glucose Meter indicates a Sample Error, this may be due to incorrect application of blood or control solution to the test strip, or the test strip may be damaged. Discard the test strip and repeat the test with a new one.
What to do if my Trividia Blood Glucose Meter shows a 'Used/Damaged Test Strip Error'?
If your Trividia Blood Glucose Meter displays a 'Used/Damaged Test Strip Error', discard the old test strip and repeat the test with a new test strip.
Why won't my Trividia Blood Glucose Meter turn on after inserting the test strip?
If your Trividia Blood Glucose Meter doesn't turn on after inserting the test strip, here are a few things to check: 1. Make sure the test strip is inserted correctly. Remove the test strip and re-insert it correctly into the meter. It shouldn't be upside down or backwards. 2. Ensure the test strip is fully inserted. Remove the test strip and re-insert it correctly into the meter. 3. Try a new test strip. Remove the current test strip and repeat with a new one. 4. Check the battery. Remove the test strip, replace the battery in the meter, ensuring the positive (“+”) side is facing up, and use a new test strip for testing.
What does 'Low Battery' mean on my Trividia Blood Glucose Meter?
The 'Low or Dead Battery' message on your Trividia Blood Glucose Meter indicates the battery's status. When the battery is low, you can still perform about 20 tests. When the battery is dead, a battery symbol appears, and the meter turns off when you insert a test strip.
Illustrates the two essential steps for performing a quick blood glucose test.
Provides reference ranges for blood glucose levels in individuals without diabetes.
Covers the TRUE FOCUS system and the significance of blood glucose monitoring.
Details hygiene, sharing, contamination, and specific patient groups for safe use.
Details about the meter's buttons, display, and test port for operation.
General| Test Time | 4 seconds |
|---|---|
| Display | LCD |
| Operating Temperature | 50 - 104°F (10 - 40°C) |
| Measurement Range | 20-600 mg/dL |
| Sample Size | 0.5 μL |
| Memory | 500 results with date and time |
| Battery Type | CR2032 |
| Battery | One 3-volt CR2032 lithium battery |
| Battery Life | Approximately 1, 000 tests |
| Relative Humidity | 10-90% |
To Next Page
