TRNDlabs FADER - Battery Safety Instructions

32
Baery Safety Instrucons
FCC Compliance Informaon (USA only)
• For the best performance, only use fresh 1.5V Alkaline “AAA” baeries in the
controller.
• Never operate the drone with low controller baeries
• The drone automacally switches o if the rotors are unable to rotate.
Switch the power to restart the drone.
• When not in use, store the drone in the original packaging with the baeries
removed from the controller.
• Always recharge the baery aer use in order to prevent it becomes deep
discharged. Make sure to allow a pause of about 20 minutes between
nishing the ight and recharging the baery.
• Even if the drone is not in regular use, recharge the baery occasionally,
suggested at least once every 2-3 months.
• When transporng or temporarily storing the rechargeable baery, the
temperature should be between 5-50 C. Do not store the baery or the
drone in a car and do not expose it to direct sunlight. In case the baery is
overheated it can be damaged or catch re.
• Do not submerge the drone or the controller in water. This will damage the
electronic components and could pose a severe risk to the built-in baery.
This device complies with part 15 of the FCC Rules. Operaon is subject to the
following two condions: (1) This device may not cause harmful interference,
and (2) This device must accept any interference received, including
interference that may cause undesired operaon. Changes or modicaons
not expressly approved by the party responsible for compliance could void the
user’s authority to operate the equipment.