TRNDlabs FADER - Setup; Charging FADER; Controller Battery Installation

8 9
Setup
Charging FADER Controller Baery Installaon
Connect the Micro USB Charging Cable to a USB port
1
and the baery
of the drone.
2
A green LED light on the baery will indicate it is charging.
When the baery is fully charged, the LED light on the baery turns o. It
takes about 30 minutes to recharge a discharged baery.
Slide the baery out of the drone by pulling it gently.
Make sure you only charge the rechargeable baery with the supplied
USB Charging Cable. If you try to charge the rechargeable baery
with a dierent baery charger, this might cause serious damage.
WARNING
Slide the Mobile Phone Holder from
closed posion to open posion. You
can now place a mobile phone.
Mobile Phone Holder Preparaon
2
1
Open the Controller baery cover.
2
Install 4x 1.5V AAA baeries.
3
Slide the Controller baery cover back.
1
2
3
1