UV systems disinfect the water using ultraviolet light, treating the water as it passes through the system. When
there is a risk that water downstream of the UV system has been contaminated, it is critical that these water lines
be chemically disinfected. Disinfection of the water lines is therefore required after initial system installation and
following any period of time during which the system is inoperative, whether due to an alarm condition, a power
failure, or for any other reason. Make sure the UV system is on during the entire disinfecting process.
1
4
5
6
73
8
Plus models only:
Unplug power supply and then unplug
sensor from blue jack.
1
2
2
Make sure power supply is plugged in for
entire disinfection process.
To Next Page
Loading...
