ASSEMBLY STEPS
STEP 5: COMPUTER INSTALLATION
Remove 2 x Phillips Screw (40) from the
Computer (39).
Connect the Extension Sensor Wire (38) and Hand
Pulse Sensor Wires (41) to the wires that come from
the Computer (39). Tuck wires into the Handlebar
Post (3). Attach the Computer (39) onto the top end
of the Handle bar Post (3) with 2 x Phillips
Screws (40) that were removed. Tighten bolts with
the Multi Hex Tool with Phillips Screwdriver provided.
Connect the Transformer (71) into the hole of
Power Connector.
STEP 5
TOOL:
Multi Hex Tool with Phillips Screwdriver
S13, S14, S15
To Next Page
Loading...
