Trojan ELITE 3000 - Page 23

23
10396
OPERATION INSTRUCTIONS
FIGURE 21
FIGURE 23
FIGURE 25
FIGURE 22
FIGURE 24
FIGURE 26
BODY FAT:
1. In STOP mode, press the BODY FAT key to start body fat measurement.
2. Console will remind to input user GENDER (Figure 21), AGE, HEIGHT, WEIGHT, then begin to measure.
3. During measuring, users have to hold both hands on the hand grips. And the LCD will display “= ” “= = ” (Figure 22)
for 8 seconds until computer nish measuring.
4. LCD will display BODY FAT advice symbol, BODY FAT percentage (Figure 23), BMI (Figure 24) for 30 seconds.
5. Error message:
*The LCD displays “= =”,“= =” (Figure 25)–means not hand the grip or wear chest strap correctly.
*E-1–There is no heart rate signal input detected.
*E-4–Occurs when FAT% is below 5 or exceeds 50 and BMI result is below 5 or exceeds 50 (Figure 26).
NOTED:
1. After 4 minutes without pedaling or pulse input, console will enter into power saving mode. Press any
key may wake the console up.
2. When computer act abnormal, please plug out the adaptor and plug in again.
APP:
1. This console can connect APP on the smart device by Bluetooth or Tunelinc.
2. Once console is connect to smart device via Bluetooth or Tunelinc, the console will power off.