Trojan MULTIFUNTION SMITH MACHINE - Page 47

47
ASSEMBLY STEPS
128
129
128
115
129
110
109
ASSEMBLY STEPS
STEP 65:
1. Attach the Seat Pin (123) to the Seat Frame (122)
with an M4 x 19 mm Self-tapping Screw (82).
2. Insert the Seat Pin into the Seat Frame and the
Bench Frame (107).
3. See step 60. Tighten the M8 Locknuts (78).
4. See step 61. Tighten the M6 x 45 mm Screws
(146).
STEP 66:
1. Insert a Pad Tube (129) through the Leg
Lever (110).
2. Slide a Foam Pad (128) onto each end of the
Pad Tube (129).
3. Attach the other Pad Tube (129) in the same way.
4. Attach the Long Pad Tube (115) to the Front
Leg (109) in the same way.
STEP 66
110
128
128
129
109
129
115
123
82
122
107
107
122
123
82
STEP 65
114
113
34
STEP 67:
1. Attach the Curl Pad (114) to the Curl Post (113)
with two M6 x 20 mm Screws (34).
STEP 67
34
113
114
#21M05T035 Multifunction Smith Machine UM A4.indd 47 2021/06/24 11:28 AM