Trojan PACE 360 - STEP 5: UPRIGHT INSTALLATION; STEP 6: HANDLEBAR ATTACHMENT

10168-10
STEP 5
• Removethe4M8x15mmButtonScrews(34),4M8
Split Washers (42) and 4 Curved Washers (68) from the
Frame (1).
• WhileanotherpersonholdstheUpright(13)nearthe
Frame(1),connecttheExtensionWire(64)totheReed
Switch Wire (39). Connect the Resistance Cable (23) to
the Lower Cable (29).
• PushtheWires(64,39)andtheCables(23,29)intothe
Frame (1).
• InserttheUpright(13)intotheFrame(1).
• AttachtheUpright(13)with4M8x15mmButton
Screws (34), 4 M8 Split Washers (42) and 4 Curve
Washers (68).
STEP 6
• AttachtheHandlebar(50)totheweldedmetalclampof
Upper Front Post (13) and secure with Spacer (54),
Decoration Cover (67) and Wing Knob Nut (44).
ASSEMBLY STEPS
Caution: Ensure that cables are not damaged
during assembly or when tightening screws
Caution: Ensure that cables are not damaged
during assembly or when tightening screws