10
ASSEMBLY STEPS
1. PREPARATION
• Before assembling make sure that you will have enough space around the item.
• Use the supplied parts and hardware for the assembly.
• Before assembling, please check whether all the required parts have been supplied as per the exploded
drawing on the opposite page.
STEP 1: FRONT / REAR STABILISERS ASSEMBLY
Attach the Front Stabiliser (Ø60 mm) (2) onto the front curved plate of the Main Frame (1) with 2 Cap
Nuts (M8) (30), 2 Bolts (M8 x 70 mm) (17), and 2 Big Curved Washers (Ø25 mm x Ø8 mm) (15).
Attach the Rear Stabiliser (Ø60 mm) (3) onto the rear curved plate of the Main Frame (1) with 2 Cap Nuts (30),
2 Bolts (M8 x 70 mm) (17), and 2 Big Curved Washers (Ø25 mm x Ø8 mm) (15).
Tighten the bolts with the provided Screwdriver.
STEP 1
To Next Page
Loading...
