Trojan PULSE 260 - STEP 6: CONSOLE ASSEMBLY

16
STEP 6: CONSOLE ASSEMBLY
Attach the Mid-handlebar Post (34) on the Upright Post (26) with 2 Screws (M8 x 30 mm) (5) and 2 Spring
Washers (Ø8) (4), through the Cover (6).
Connect the Mid-sensor Wire 1 (49) to the Console Wire on the Console (50) and attach the Console (50) to the
Upright Post (26) with 2 Screws (M5 x 10) (23). Insert the Pulse Wire (37) into the back of the Console (50).
STEP 6
ASSEMBLY STEPS