HOW TO APPLY LUBRICANT
Lift one side of running belt.
Pour one half of the lubricant bottle under the centre of the running belt on the top surface of the running deck.
Walk on the treadmill at a slow speed for 3 to 5 minutes to evenly distribute lubricant.
NOTE: DO NOT over lubricate running deck. Any excess lubricant that comes out should be wiped off.
NOTE: ONLY USE HALF THE BOTTLE OF LUBRICANT PER APPLICATION
LUBRICATION SCHEDULE.
1. Check the treadboard lubrication during installation. If it is necessary, lubricate the treadboard, using the full bottle of
lubricant provided, before using the treadmill for the first time.
2. If the treadmill is used on a regular basis, the running deck should be lubricated once a month.
3. If the treadmill is not used for two months or more, the treadmill must be lubricated before use.
6. MAINTENANCE
Your treadmill should require little maintenance other then
periodically applying lubricant. Lubricating under the running
belt will ensure superior performance and extend the
treadmill’s life expectancy.
HOW TO CHECK TREADBELT FOR PROPER
LUBRICATION
Lift one side of the treadbelt and feel the top surface of the
treadboard.
If the surface is slick to the touch, then no further lubrication
is required.
If the surface is dry to the touch, apply half the bottle of lubri-
cant to the surface beneath the belt. If the lubricant is finished
Dubbin can be used. No other lubricant should be used.
BELT TRACKING ADJUSTMENT
If during use you notice that the running belt either shifts
to the right or the left of center, first remove “Safety Key”
and unplug equipment from AC power source. Using
Allen wrench (e) provided, turn left rear roller adjustment
clockwise no more the 1/4” of a turn. Remove Allen wrench,
insert “Safety Key” and insert AC power cord into AC outlet.
Turn on your treadmill and observe after running for a few
minutes to see if the problem has been corrected. This may
take several adjustments, so repeat the above procedure.
To Next Page
Loading...
