35
2902 Walkaround • Owner’s Manual Supplement Chapter 6: Plumbing
System View
Filling & Using the Baitwell
1. Open the seawater
pickup seacock.
2. On the main switch panel, turn On
the baitwell.
The tank should now be filling with
water. If water is not pumping into the
tank, possible causes are:
• A collapsed hose or clogging
debris in the system.
• The seacock is closed.
• The baitwell fuse is blown.
Aeration Tips
The level of aeration is controlled by the aerator control valve.
• In clean ocean water little or no aeration is needed.
• In brackish backwaters a higher level of aeration may be needed.
To Drain the Baitwell
Open the drain seacock located in the starboard
access hatch in the transom walkway.
AERATOR VENT
SEAWATER
PICKUP PUMP
SEAWATER PICKUP
& SEACOCK
SEAWATER STRAINER
OVERFLOW
DRAIN THRU-HULL
AERATOR CONTROL VALVE
DRAIN SEACOCK
& THRU-HULL
TANK
BAITWELL
SWITCH
MAIN SWITCH
PANEL
ACCESS HATCH
To Next Page
Loading...
