Trotec IDE 20 - Disposal; Declaration of Conformity

28 EN
oil heater IDE 20 / IDE 30 / IDE 50 / IDE 60 / IDE 80
Disposal
Always dispose of packing materials in an environmentally
friendly manner and in accordance with the applicable local
disposal regulations.
The icon with the crossed-out waste bin on waste
electrical or electronic equipment stipulates that this equipment
must not be disposed of with the household waste at the end of
its life. You will find collection points for free return of waste
electrical and electronic equipment in your vicinity. The
addresses can be obtained from your municipality or local
administration. You can also find out about other return options
that apply for many EU countries on the website
https://hub.trotec.com/?id=45090. Otherwise, please contact an
official recycling centre for electronic and electrical equipment
authorised for your country.
The separate collection of waste electrical and electronic
equipment aims to enable the re-use, recycling and other forms
of recovery of waste equipment as well as to prevent negative
effects for the environment and human health caused by the
disposal of hazardous substances potentially contained in the
equipment.
Fuel oil
The fuel oil must be drained from the device and collected.
Fuels are to be disposed of according to the national
regulations.
Declaration of conformity
Declaration of conformity in accordance with the ECMachinery
Directive 2006/42/EC, AnnexII, Part1, SectionA
We– Trotec GmbH– declare in sole responsibility that the
product designated below was developed, constructed and
produced in compliance with the requirements of the
ECMachinery Directive in the version 2006/42/EC.
Product model/ product:
IDE20, IDE30,IDE50
Product type:
oil heater
Year of manufacture as of:
2022
Relevant EUdirectives:
• 2011/65/EU
• 2012/19/EU
• 2014/30/EU
• 2015/863/EU
Applied harmonised standards:
• EN 60335-2-102:2016
Applied national standards and technical specifications:
• EN 60335-1:2012/A1:2019
• EN 60335-1:2012/A14:2019
• EN 60335-1:2012/A2:2019
• EN 62233:2008
• EN IEC 55014-1:2021
• EN IEC 55014-2:2021
• EN IEC 61000-3-2:2019
• EN IEC 61000-3-2:2019/A1:2021
• EN 61000-3-3:2013
• EN 61000-3-3:2013/A1:2019
Manufacturer and name of the authorised representative of
the technical documentation:
Trotec GmbH
Grebbener Straße 7, D-52525 Heinsberg
Phone: +49 2452 962-400
E-mail: info@trotec.de
Place and date of issue:
Heinsberg, 8 July 2022
Joachim Ludwig, Managing Director