EasyManuals Logo

Trotec IDE 20 User Manual

Trotec IDE 20
30 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #3 background imageLoading...
Page #3 background image
EN 3
oil heater IDE 20 / IDE 30 / IDE 50 / IDE 60 / IDE 80
Safety
Read this manual carefully before starting or using the
device. Always store the manual in the immediate vicinity
of the device or its site of use.
Warning
Read all safety warnings and all instructions.
Failure to follow the warnings and instructions may
result in electric shock, fire and/or serious injury.
Save all warnings and instructions for future
reference.
This device must not be used by children and persons
under16years of age.
Children shall not play with the appliance. Cleaning and
user maintenance shall not be made by children
under16years.
Warning
Do not use the device in rooms if persons are present
who cannot leave the room independently and who are
not under constant supervision.
Do not use the device in potentially explosive rooms or
areas and do not install it there.
Do not use the device in aggressive atmosphere.
Only put up the device in an upright, stable position on firm
ground.
Let the device dry out after a wet clean. Do not operate it
when wet.
Do not use the device with wet or damp hands.
Do not expose the device to directly squirting water.
Never insert any objects or limbs into the device.
Do not cover the device during operation.
Do not remove any safety signs, stickers or labels from the
device. Keep all safety signs, stickers and labels in legible
condition.
Attention: In Germany, the Federal Emission Protection
Directive applies. Do not operate the device for more than
3months at the same place. Prior to planning the flue gas
system, gather information about the national legislation
and contact a responsible specialist.
Do not sit on the device.
This device is not a toy. Keep away from children and
animals. Do not leave the device unattended during
operation.
Check accessories and connection parts for possible
damage prior to every use of the device. Do not use any
defective devices or device parts.
Ensure that all electric cables outside of the device are
protected from damage (e.g. caused by animals). Never
use the device if electric cables or the power connection
are damaged!
The mains connection must correspond to the
specifications in the Technical annex.
Insert the mains plug into a properly fused mains socket.
Observe the device's power input, cable length and
intended use when selecting extensions to the power
cable. Completely unroll extension cables. Avoid electrical
overload.
Before carrying out maintenance, care or repair work on
the device, remove the mains plug from the mains socket.
Hold onto the mains plug while doing so.
Switch the device off and disconnect the power cable from
the mains socket when the device is not in use.
When positioning the device, observe the minimum
distances from walls and other objects as well as the
storage and operating conditions specified in the Technical
annex.
Make sure that the air inlet and outlet are not obstructed.
Make sure that the suction side is kept free of dirt and
loose objects.
Do not place the device on combustible ground.
Only transport the device in an upright position.
Only use original spare parts, for otherwise safe and
functional operation cannot be ensured.
Do not use the heating device together with a
programming device, a timer, a separate remote control
system or any other device that automatically switches the
heating device on, as there is a risk of fire if the heating
device is covered or incorrectly positioned.
Intended use
The device was developed for the purpose of generating hot air
and may only be used in roofed over outdoor areas or in well-
ventilated interior spaces whilst adhering to the technical data.
The device is suited for heating large rooms such as tents,
warehouses, workshops, construction sites, greenhouses or
agricultural halls.
It is intended to be used without frequent site changes.
The device may only be used in rooms with sufficient fresh air
supply and exhaust discharge.
The device must only be operated with EL (ultra-light) fuel oil,
kerosene and diesel, however not with petrol, heavy fuel oil etc.

Other manuals for Trotec IDE 20

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Trotec IDE 20 and is the answer not in the manual?

Trotec IDE 20 Specifications

General IconGeneral
BrandTrotec
ModelIDE 20
CategoryHeater
LanguageEnglish

Related product manuals