To Next PageTo Next Page
Need help?Do you have a question about the Trotec Speedy C12 and is the answer not in the manual?
General| Laser Type | CO2 laser |
|---|---|
| Resolution | up to 1000 dpi |
| Interface | USB |
| Software | JobControl |
| Engraving Speed | Up to 1, 000 mm/s |
| Supported Materials | Wood, acrylic, glass, leather, textiles |
| Power Supply | 230 V / 50 Hz |
General safety precautions for operating the laser engraver.
Information on laser safety classes, hazards, and US classifications.
Details electrical dangers and precautions for service.
Explains system indicators, warnings, and safety labels.
Steps and requirements for laser beam alignment.
Steps for adjusting the laser pointer.
Information on laser tube requirements and reasons for replacement.
Instructions for replacing 12W and 25W laser tubes.
Instructions for replacing 50W and 100W laser tubes.
Tensioning the X-gearing belt.
Tensioning the X-main belt.
Steps to remove the X-gearing assembly.
Reassembling the X-gearing assembly.
Steps to update the firmware via the manager.
Procedure for updating firmware directly via CPU board.
List and explanation of software error codes.
Using self-test and error codes for hardware issues.
