Trotec Laser Cut Guide (FineCut version)
This "Trotec Laser Cut Guide", describes the cutting method for the Trotec Speedy series of laser engraving
machines 100/300/360/400 that use the software bundled with Mimaki printers and the Trotec Speedy Laser
Engravers.
Notice
• It is strictly prohibited to write or copy a part or whole of this document without our approval.
• This document has been carefully prepared for your easy understanding, however, please do not hesitate to
contact a distributor in your district or our office if you have any inquiry.
• Description contained in this document are subject to change without notice for improvement.
• Due to improvement or change of this software, the description of this document could be partially different in
specification, for which your understanding is requested.
• Except for the damages prescribed in Warranty Notes of MIMAKI Engineering Co., Ltd. assumes no responsibil-
ity for effects (including loss of income, indirect damages, special damages, or other financial damages) result-
ing from the use or non-use of the product. This also applies to the case when MIMAKI Engineering is notified of
the possibility of damages. For example, MIMAKI Engineering Co., Ltd. assumes no responsibility for damages
of media (work) caused by using this product and indirect damages caused by a product created using the
media.
• You can also download the latest version of this document from our website.
Trotec Speedy Laser Engravers
, Trotec JobControl, Trotec UniDrive, and Trotec Engraver are registered trade-
marks of Trotec Laser GmbH.
FineCut and RasterLink are registered trademarks of MIMAKI ENGINEERING CO., LTD.
Adobe and Illustrator are trademarks of Adobe Systems Incorporated.
Microsoft and Windows are registered trademarks of Microsoft Corporation in the United States and other coun-
tries.
Apple and Macintosh are registered trademarks of Apple Inc. in the U.S.A and other countries.
All brand names and product names are trademarks or registered trademarks of their respective companies.
To Next Page
Need help?
General
