Trotec Speedy Series User Manual

- 30 -
Modifying the cutting order
The following two methods can be used.

To cut from the lowest layer, change the order
of the layers in Adobe Illustrator.
 In the Trotec JobControl [Material database],
check the order of the colors to be cut, and
modify the line color of the cut data in Adobe
Illustrator.
1. Launch Trotec JobControl.
2. Select [Material Template Setup] on the
[Settings] menu.
3. Check the order of the colors on the
[Material database] dialog.
4. In Adobe Illustrator, change the line color
of the cut data according to the cutting
order. ( P.16 "Select the line color for
the cut data from the Trotec color
swatch.")
• Be sure to set the line colors of the cut data in the
Trotec color swatch.

Trotec Speedy Series Specifications

General

Resolution	Up to 1000 dpi
Laser Type	CO2 laser
Work Area	Varies depending on model
Max. Workpiece Height	Varies depending on model
Laser Power	Varies by model
Software	JobControl
Supported File Formats	AI, BMP, PDF, DXF, PLT, JPG, GIF, TIFF, PNG
Cooling	Air or Water (depending on laser power)
Power Supply	50/60 Hz