*1. Alignment frame: This is a frame that acts as a reference to prevent shifting during printing and cutting. All data must
be created so that it fits within this frame.
1. Create the data (P.16)
3. Laser cutting using the Trotec Speedy Laser Engraver (100/300/360/400)
Printing and cutting (P.16)
1. Create the data using Adobe Illustrator (P.16)
• Create the print data, cut data, and alignment frame
*1
data.
1. Set the media. (P. 21)
2. Output from FineCut to the Trotec Speedy Laser Engraver. (P. 21)
2. Printing (P.17)
1. Printing the alignment frame data on paper media (P.17)
2. Printing the print data on media (P.19)
To Next Page
Loading...
