Trotec T660 Operation Manual

8 EN
moisture measuring device T660
Exiting configuration mode
Configuration mode will automatically be terminated after 8
seconds without entry.
You can quit configuration mode yourself anytime. Please note
that in such an event no changes made to the settings will be
adopted.
1. Press the Right/back key(8) for approx. 2 seconds.
ð Configuration mode will be terminated.
Measuring mode
1. Press the keys Right/back(8) or Left/menu(11) until the
desired measuring mode is displayed.
2. The selected measuring mode(13) will be indicated on the
display(1)
13
15
14
16
The device comes with the following measuring modes:
Measuring
mode
Description
ACT Measured value in real time
AVG Average value of measurements since switch-on
Min Minimum measured value
Max Maximum measured value
HOLD Measured value will be held
Holding the measured value
1. Set the measuring mode to HOLD.
ð The current measured value will be held and displayed.
ð The device will hold this value until the measured values
are set back or the device is switched off.
Resetting the measured values
1. Press the OK button(10) for approx. 2 seconds.
ð All previously stored measured values of the measuring
modes AVG, MIN, MAX and HOLD will be set back.
ð All previously stored measured values of the measuring
modes AVG, MIN, MAX and HOLD will be set back.
Measured value storage
Please note that measured values cannot be saved on the
device itself. In order to save measured values, the device has
to be connected to a PC via a USB cable using the MultiMeasure
Studio software.
1. Briefly press the OK button(10).
ð The displayed measured value will be saved in the
software.
Checking current settings
1. Press the Right/back key(8) for approx. 2 seconds.
ð The selected settings are indicated in the two
measurement value displays(14, 16).
USB interface
The device can be connected to a PC via the USB interface(5).
See chapter PC software.
Switch-off
1. Press and hold the On/Off button(4) for approx.3seconds
until a beep is emitted.
ð The device is switched off.

Trotec T660 Specifications

General

Penetration Depth	Up to 40 mm
Operating Temperature	0 °C to +50 °C
Measurement Range	0 to 200 digit
Resolution	0.1 digit
Display	LCD