ConnectHoseandWaterSupplyto Pump
NOTICE DO NOTrun the pump without the water supply
connectedand turned on.
• Damagetoequipmentresultingfrom failuretofollowthis
instructionwill voidwarranty.
NOTE:Remove and discard the shipping caps from the
pump's high pressure outlet and water inlet before attaching
hoses.
1. Uncoil high pressure hose and attachone end of hose
to base of spray gun. Tighten by hand.
_i, WARNING The high pressure stream of water that
this equipment produces can cut through skin
and its underlying tissues, leading to serious
injury and possible amputation.
• NEVERconnect high pressure hose to nozzleextension.
• Keephigh pressure hose connectedto pump and spray gun
while system is pressurized.
• Always be certain spray gun, nozzlesand accessoriesare
correctly attached.
2. Attach other end of high pressure hose to high
pressure outlet on pump. Tighten by hand.
3. Before connecting garden hoseto water inlet, inspect
inlet screen (A). Cleanscreen if it contains debris or
haveit replaced if damaged.DONOTrun pressure
washer if inlet screen is damaged.
4. Run water through your garden hose for 30 secondsto
cleanout any debris.
IMPORTANT:DONOTsiphon standing water for the water
supply. UseONLY cold water (less than 100°F (38°C)).
NOTICE Using a OneWayValve (vacuum breaker or check
valve) at pump inlet cancause pump or inlet connector
damage.
• ThereMUSTbeatleasttenfeetof unrestrictedgardenhose
betweenthepressurewasherinletandanydevice,suchasa
vacuumbreakeror checkvalve.
• Damageto equipment resulting from failure to follow this
instruction will void warranty.
5. Connectthe garden hose (not to exceed50 feet (15 m)
in length) to the water inlet. Tighten by hand.
A, WARNING Risk of eyeinjury.
Spray cansplash back or propel objects.
• Always wear indirect vented (chemical splash) safety goggles
markedto comply with ANSI Z87.1 when using or in vicinity of
this equipment.
• NEVERsubstitute safety glasses or dry-condition goggles for
indirect vented safety goggles.
6. Turn ONthe water, press red button (B) on the gun and
squeezethetrigger to purge the pump system of air and
impurities.
ChecklistBeforeStarting Engine
Reviewthe unit's assembly to ensureyou have performed all
of the following.
1. Be sureto readthe Operator Safety section and Howto
Use Your Pressure Washerin Operation section before
using pressurewasher.
2. Make sure handle is in placeand secure.
3. Checkthat oil has been addedto proper levelin the
engine crankcase.
4. Add proper fuel to fuel tank.
5. Checkfor properly tightened hose connections.
6. Checkto make sure there are no kinks, cuts, or damage
to high pressure hose.
7. Provide a proper water supply at an adequateflow.
To Next Page
Loading...
