B. Turn the Wheel Speed
Adjustment Knob (on end of
lever) until the arrow on the knob
points to the desired setting: 1
(slow) to 5 (fast). See Figure 4-7.
C. Move the Wheel Drive Lever
forward to engage the wheels and
begin mowing.
Slow I_Tu rn
Fast
Figure 4-7: To set wheel speed, put
Wheel Speed Lever in DISENGAGE
position and turn adjustment knob
to desired speed setting.
STEP 3: Stopping
A. Move the Wheel Drive Lever
back to the DISENGAGE posi-
tion to stop the wheels.
B. Release the Operator Presence
Control Bar. This will stop the
engine and stop the mower blade
within three seconds.
NOTE: To stop the mower in an
emergency, merely release the
Operator Presence Control Bar.
IMPORTANT: Always store the
mower with the Wheel Drive
Lever in DISENGAGE and with
the knob in one (1) to prevent
accidentally starting the mower
at a FAST wheel speed.
22
To Next Page