SECTION
6:
Tiller
Attachment
Transmission
PTO
HORSE
MODEL
TECHNICAL
MANUAL
Page
6-6
4/90
-.
. '-
...
are not sufficient, use
two
.030"
gaskets, etc. until the shaft is
shimmed correctly.
Note:
No
more than .060" in total
gasket thickness should be
needed
to
correctly shim the tine
shaft. Call the Troy-8i1t Technical
Service Department if more than
.060" shimming
is
required.
d. There should be no end play,
vertical play
or
diagonal play in
the tiller tine shaft. If you find such
play, tighten the tiller housing
cover bolts.
If this does not eliminate the play,
insert a shim (Part No. 1447-1,
1447-2
or
1447-3) between the
gear and bearing on the tiller tine
shaft.
13.
Repeat the previous
two
steps until you feel the correct
amount
of
play in the tiller tine
shaft.
14.
Using new washers (2), fully
bolt the cover in place. These are
nylon washers that function
as
an
oil sealer. If the washers are
not
available, coat the tips of the bolts
with a non-hardening gasket
sealer.
15.
Apply
a layer of
non-
hardening gasket sealer
to
the
outside edge
of
an
oil seal. Then
install the oil seal on the right side
of
the tiller housing so that the
seal
is
flush with the housing.
16.
Apply a layer of
non-
hardening gasket sealer
to
the
outside edge of another oil seal.
Then install the oil seal on the left
side
of
the tiller housing so that
the outside edge of the seal
is
flush
with the housing.
17.
Refill the housing with gear
oil according
to
the instructions
found
in the
Owner/Operator
Manual.
To Next Page
Loading...
