Troy-Bilt Flurry 1400

Other manuals for Troy-Bilt Flurry 1400

Questions and Answers

L
lunascottAug 9, 2025
What to do if my Troy-Bilt Flurry 1400 Snow Blower won't start?
- B
  brandiandrewsAug 9, 2025
  If your Troy-Bilt Snow Blower won't start, there are several potential causes: * Ensure the key is properly inserted. * Check if the cord is disconnected from the motor control and reconnect it, keeping the cord restraint close to the motor control. * The motor control may be defective, requiring replacement. * Verify the extension cord is connected to the plug on the snow thrower. * Confirm the extension cord is connected to a 110-120 volt, 60 hertz AC receptacle. * Check if the circuit breaker reset button on the snow thrower or the circuit breaker in the house receptacle has tripped. If so, reset it following the instructions in the Maintenance & Adjustments section.
J
Jon BryanAug 14, 2025
Why does the circuit breaker on my Troy-Bilt Snow Blower keep tripping?
- K
  Karen DaltonAug 14, 2025
  The circuit breaker on your Troy-Bilt Snow Blower might be tripping due to: 1. Too much workload on the snow thrower. Reset the circuit breaker, reduce the width of cut, and walk more slowly. 2. A blown fuse or an overloaded outlet. Connect to an outlet fused for 15 or 20 amperes and reset the circuit breaker before restarting the snow thrower.
D
Deborah CohenAug 19, 2025
How to stop my Troy-Bilt Flurry 1400 cord from disconnecting?
- K
  Kristin WashingtonAug 19, 2025
  To prevent the cord from frequently disconnecting on your Troy-Bilt Snow Blower: * Ensure the extension cord is properly attached to the cord restraint on the guide rod. Reconnect if necessary. * The extension cord may be old, worn, or loose, requiring replacement.
M
Makayla BatesAug 25, 2025
Why is my Troy-Bilt Snow Blower not discharging snow?
- L
  lcookAug 25, 2025
  If your Troy-Bilt Snow Blower isn't discharging snow, consider these possibilities: * The chute assembly might be clogged. Stop the motor, unplug the power cord, and clean the chute and inside of the auger housing with a clean-out tool or stick. * A foreign object could be lodged in the auger. Immediately stop the motor, unplug the power cord, and remove the object from the auger. * The auger belt may be loose or damaged, requiring replacement.
T
Thomas RodriguezAug 29, 2025
Why is my Troy-Bilt Flurry 1400 Snow Blower not self-propelling?
- G
  gthomasAug 29, 2025
  Your Troy-Bilt Snow Blower may not be self-propelling because: 1. The auger control cable is out of adjustment. Adjust the auger control cable as shown in the Maintenance & Adjustments section. 2. The auger drive belt is loose or damaged. Replace the auger drive belt.
H
Haley MccallSep 3, 2025
What causes a Troy-Bilt Snow Blower to vibrate at a high speed?
- L
  Laura ByrdSep 3, 2025
  If your Troy-Bilt Snow Blower is vibrating at a higher speed, it could be due to a bent motor shaft or damaged auger. Stop the motor, disconnect the power source, and inspect for damage. Have it repaired by an authorized service dealer.