True ALPINE RUNNER - Page 42

CHAPTER 6: ADDITIONAL INFORMATION
Truetness.com / 800.426.6570 / 636.272.7100
42 of 50
Fault SC02: Incline Stall
Smart
Card
Incline Stall
Console displays Fault
Calibration not saved.
Incline disabled.
Power cycle
Check cable connections
Run incline calibration
Incline Potentiometer value
out of range
Contact dealer or TRUE service
Acme Nut Jammed
Motor Bearings
Fault SC03: Incline Run
Fault
Smart
Card
Incline Runaway
Console displays Fault
Calibration not saved.
Incline disabled.
Power cycle
Check cable connections
Run incline calibration
Incline Potentiometer value
out of range
Contact dealer or TRUE
service
Acme Nut Jammed
Motor Bearings
Fault SC04: Motor
Under Speed
Smart
Card
Underspeed
High Belt Deck Friction
Lubricate treadbelt
Contact dealer or TRUE
service
High belt tension
Check drive belt and walking
belt tension
Low Line Voltage
Check AC line voltage
Dirty or misaligned speed
sensor
Contact dealer or TRUE
service
Fault SC05: Motor Over
Speed
Smart
Card
Overspeed
High Belt Deck Friction
Lubricate treadbelt
Contact dealer or TRUE
service
Line Voltage Check AC line voltage
Dirty or misaligned speed
sensor
Contact dealer or TRUE
service
Fault SC06: Motor
Acceleration Fault
Smart
Card
Excessive
Acceleration
User is holding belt back Do not try to stop belt
High Belt Deck Friction Lubricate treadbelt
Dirty or misaligned speed
sensor
Contact dealer or TRUE
service
Fault SC07: Speed
Sensor Fault
Smart
Card
No Speed Card
Dirty or misaligned speed
sensor
Contact dealer or TRUE
service
High Belt Deck Friction
Lubricate treadbelt
Contact dealer or TRUE
service
Low Line Voltage Check AC line voltage