CHAPTER 2: ASSEMBLY INSTRUCTIONS
TREADMILL ASSEMBLY STEPS (continued):
STEP 13: Unit Leveling (if needed):
a) Ensure treadmill incline
rack wheels and rear feet are
resting on the floor.
b) Using a 15/16 inch
open end wrench, loosen
nut (A) the Rear Foot.
c
) Us
ing a level or estimating by
sight, turn section (B) of foot
clockwise, or counter-clockwise,
using a 7/8 inch open end wrench to
level the unit.
d) Tighten nut (A) until it is secured
against bottom of treadmill.
STEP 14: Attach Safety Key:
attachment cord are wrapped around
plate during shipping as shown.
a) Unwind safety key and cord from
plate.
) Attach Safety Key magnet to front
o
f Center Pod as shown.
d) Attach Safety Key clip to plate
l
ocated on Console Rack (when not
working out).
e) Attach clip to clothing at
the
b
eginning of any workout.
C
AUTION: Read treadmill Owner’s
Manual before attempting any
workout.
ATTACHED
Truefitness.com / 800.426.6570 / 636.272.7100 18
To Next Page
Loading...
