7EN
Pairing the electronic control unit with the
radio remote control
The remote control and control unit are paired in the
factory.
If the control unit or the remote control is replaced, they must
be paired again as described below.
Check that installation has been carried out in accordance
with the installation instructions, and make sure that the drive
rollers are not touching the tyres. Check that the caravan bat-
tery is properly connected and is in good condition.
Read the following instructions beforehand, as you only
have limited time for pairing (approx. 10 seconds).
You will need a pen, a small screwdriver or similar to
press the reset button (k).
– Switch off the remote control with the slide switch (a).
– After switching on the control unit (e.g. battery cut-off
switch), wait (for about 15 seconds) until the red LED (j)
starts flashing slowly.
– Press the reset button (k) on the control unit (LED (j) flashes
more rapidly) until the red LED (j) flashes very rapidly.
– Turn the control knob (b) all the way to the left and hold it
in place – push the slide control (c) all the way forwards
and hold it in place, and at the same time switch on the re-
mote control using the slide switch (a). Release the control
knob(b) and slide control (c) within 10 seconds.
– When the devices have been successfully paired, the red
LED (j) on the control unit flashes very rapidly and the green
LED 4 on the remote control remains permanently on.
If pairing was unsuccessful, the red LED (j) flashes and
you have to repeat the process.
j
k
a
LED 4
b c
Figure 6
Declaration of conformity
Refer to the appendix
Technical Data
Description
Mover SX
Area of use
Single-axle caravans with a gross weight of up to 2000 kg
Operating voltage
12 V DC
Power consumption
Approx. 20 A on average
Maximum 120 A
Quiescent current consumption
< 20 mA
Remote control frequency
Class 1, 868 MHz
Speed
Approx. 16 cm per second (depending on weight and slope)
Weight
Approx. 35 kg
(including cross actuation device)
To Next Page
Loading...
