TSC MB240 Series User Manual

- 23 -
3.4.3 Loading Media in Peel-off Mode (Option)
1. Open the printer right side cover.
2. Please refer to section 3.4.1 for loading
media.
3. Using the front display panel to do the
calibration first and set the printer mode to
peeler mode.
Note:
1. Please calibrate the gap/black mark
sensor before loading media in the
peel-off mode to avoid the paper jam.
2. Please feed the label through media
guide bar as picture shown.
4. Open print head release lever, pull
approximately 650 mm of the label through
the front of the printer.
5. Remove several labels to leave liner.
Label
Liner

TSC MB240 Series Specifications

General

Print Method	Thermal Transfer/Direct Thermal
Resolution	203 dpi
Processor	32-bit RISC CPU
Operating Humidity	25-85% non-condensing
Connectivity	USB 2.0, RS-232
Media Sensor	Reflective, Transmissive
Media Type	Continuous, Die-cut, Black mark, Fan-fold, Notched
Media Width	25.4 mm
Media Thickness	0.06 mm
Media Core Diameter	25.4 mm (1")
Media Max Roll Diameter	127 mm (5")
Ribbon Width	110 mm
Ribbon Length	300 m
Ribbon Core Diameter	25.4 mm (1 inch)
Power	100 - 240 VAC, 50/60 Hz
Maximum Print Length	9999 mm
Label Width	25.4 mm
Label Thickness	0.06 mm
Power Supply	100-240V AC, 50-60Hz
Operating Temperature	5°C - 40°C
Storage Temperature	-20°C - 60°C
Certifications	CE