- 40 -
The direction setting value is either 1 or 0. Use this item to setup
the printout direction.
This item is used to set the print mode. There are 6 modes as
below,
Next label top of form is aligned to the print head
burn line location. (Tear Off Mode)
Once image is printed completely, label gap/black
mark will be fed to the tear plate location for tear
away.
Enable the label peel off mode.
Enable the label cutter mode.
Cut the label once at the end of the printing job.
Enable the label rewinder mode.
This item is used to fine tune media stop location. Available
setting value range is from -999 dots to 999 dots.
This item is used to fine tune print position. Available setting value
range is from -999 dots to 999 dots.
This item is used to set the origin of printer coordinate system
horizontally and vertically. Available setting range is from 0 dot to
999 dots.
Use this item to set the code page of international character set.
Use this option to set the country code. Available setting value
range is from 1 to 358.
Note: If printing from enclosed software/driver, the software/driver will send out the
commands, which will overwrite the settings set from the panel.
To Next Page
Loading...
