Why is my TSC TTP-245 not printing on the label?
If your TSC Printer isn't printing on the label, it might be due to the label or ribbon not being loaded correctly. Refer to the instructions for Loading the Paper or Loading the Ribbon to ensure they are properly installed. Another possibility is that the ribbon has run out; in this case, follow the instructions for Loading the Ribbon.
Why is the print quality poor on my TSC TTP-245?
Poor print quality on your TSC Printer can occur if the top cover isn't closed properly. Ensure the top cover is completely closed and that both the right and left side levers are properly latched. Other causes can be related to the need to clean the thermal print head, or to adjust the print density setting. It may also happen that the ribbon and paper media are not compatible.
What to do if my TSC Printer is out of label or ribbon?
If your TSC Printer is out of labels or ribbon, load a new roll of labels or ribbon following the instructions for Loading the Paper or Loading the Ribbon. Then, press the feed button to resume printing. If the printer setting is not correct, initialize the printer by following the instructions in 'Power on Utility'.
How to fix no power on TSC Printer?
If your TSC Printer has no power, check the power supply. If the green LED is not lit, the power supply is broken. Also, ensure the power switch is turned on. Check the power connections from the power cord to the power supply and from the power supply to the printer power jack.
What to do if my TSC TTP-245 is continuously feeding labels?
If your TSC Printer is continuously feeding labels, the printer settings may be incorrect. To resolve this, perform the Initialization and Gap/Black Mark Calibration.
What to do if my TSC Printer is paused?
If the TSC Printer is paused, press the feed button to resume printing.
Instructions for placing the printer, connecting cables, and plugging in power.
Steps to install a ribbon into the printer and ensure proper closure.
Details on inserting the label spindle and opening the top cover.
Steps to calibrate ribbon and gap/black mark sensor sensitivity.
Calibrates sensors, prints configuration, and enters dump mode.
Clears DRAM and resets printer settings to defaults.
Calibrates the black mark sensor as the media sensor.
General| Print Method | Thermal Transfer / Direct Thermal |
|---|---|
| Resolution | 203 dpi |
| Processor | 32-bit RISC CPU |
| Max Print Width | 108 mm (4.25") |
| Max Print Speed | 5 inches per second |
| Interface | Parallel |
| Ribbon Capacity | 300 meters |
| Label Width | 1 to 4.4 inches |
| Dimensions | 232 mm (W) x 156 mm (H) x 288 mm (D) |
| Power Supply | External Universal Switching Power Supply |
| Operating Temperature | 5°C to 40°C |
| Storage Temperature | -40°C to 60°C |
| Operating Humidity | 25% to 85% non-condensing |
| Print Length | 39.37 inches (1000 mm) |
| Label Thickness | 0.08 to 0.2 mm |
To Next Page
