- 38 -
Head Close
This option is used to set the action of the media when you
close the print head.
Printer will advance one label
Calibration
Printer will calibration the sensor levels,
determine length and feed label
Printer determine length and feed label
Printer will not move media
No
Motion
Label Top
This option is used to adjust print position vertically on the
label. The range is -120 to +120 dots.
0 dot
Left Position
This option is used to adjust print position horizontally on the
label. The range is -9999 to +9999 dots.
0
Reprint Mode
When reprint mode is enabled, you can reprint the last label
printer by pressing button on printer’s control panel.
Disabled
Format Convert
Selects the bitmap scaling factor. The first number is the
original dots per inch (dpi) value; the second, the dpi to which
None
Note: If printing from enclosed software/driver, the software/driver will send out the
commands, which will overwrite the settings set from the panel.
To Next Page
Loading...
Need help?
General
