TSC MH341T Series User Manual

- 52 -
Touchscreen
Calibration
This item is used to calibrate the center of the cross for
best result for touchscreen.
N/A
Date & Time
This item is used to setup the date and time on display.
N/A
Security
This feature is used to set the password for locking the
menu or favorites. The default password is 8888.
Disable
Ribbon Low
Warning
This item is used to set the warning for ribbon low. For
example, if setting value is 30m, when ribbon capacity was
lower than 30m, the will be shown in red.
30m
Printer Head
Maintn
This item is used to check print head status and to set the
settings for print head care.
Item
Description
Warning
This item is used to enable/disable the
print head clean warning. If enable this
feature, once print head has been
reached the setting mileage then the
warning icon will be shown on printer UI
for reminding user to clean the print
head. The default setting is disable.
Reset
Counter
This item is used to reset the print head
clean warning mileage after cleaned
print head.
Interval
This item is used to set the expected
mileage for reminding user to clean the
print head. You have to enable the “TPH
warning lock” for use. The default setting
is 1 km.
N/A
Print Quality
This item is used to select the print quality to standard/
power mode.
Standard
Key Sound
This item is used to open/close the key sound.
ON
Contact us
This feature is used to check the contact information for
tech support service
N/A

TSC MH341T Series Specifications

General

Brand	TSC
Model	MH341T Series
Category	Printer
Language	English