TSC PEX-2000 Series - Page 51

49
Note: If printing from enclosed software/driver, the software/driver will send out the commands, which will overwrite the settings set
from the panel.
Item
Description
Default
Speed
Set the print speed.
203 dpi: 6
300 dpi: 4
Slew Speed
Set feed speed
203 dpi: 6
300 dpi: 4
Back Speed
Set back speed
2
Density
Set printing darkness. Setting range: 0 to 15, and the step is 1.
8
Direction
Set the printout direction. Setting Value: 0 and 1.
Direction 0: Direction 1:
0
Print mode
Set the print mode. There are 3 modes in total:
Batch Mode: Once finishing the printing process, label will be fed to the tear plate location.
Applicator: The printer prints a label when it receives a signal from the applicator.
Rewinder Mode: Enable the label rewinder mode.
Applicator
Offset
Adjust media stop location. Available value setting range: -999 dots to 999 dots.
0 dot
Shift X
Adjust print position. Available value setting range: -999 dots to 999 dots.
0 dot
Shift Y
0 dot
Reference X
Set the origin of printer coordinate system horizontally and vertically. Available setting range: 0 dot to 999 dots.
0 dot
Reference Y
0 dot
Code page
Set the code page of international character set.
850
Country
Set the country code. Available setting value range: 1 to 358.
001