TSC Printronix MB240 Series User Manual

30
Wrinkle happens from label lower right to upper left direction
◼ Make sure the Printhead Pressure Adjustment Knob is in correct position for the current media. Ex: 1 to 2”, 3 to 4”
◼ Turn the screw clockwise per level and print to see if the winkle has gone.
◼ If the ribbon tension adjustment knob has positioned on the level of innermost side but the ribbon slack cannot be removed,
please switch the printhead pressure at 1 level and print the label again to check if the wrinkle is gone.
◼ If the wrinkle can’t be avoided, please contact the Customer Service Department of your purchased reseller or distributor for
service.
Feed Direction

TSC Printronix MB240 Series Specifications

General

Type	Industrial Barcode Printer
Resolution	203 dpi (8 dots/mm)
Media Type	Direct Thermal, Thermal Transfer
Communication Interface	USB, Serial, Ethernet
Interface	USB 2.0, RS-232, Parallel, Ethernet 10/100
Supported Barcodes	Code 39, Code 128, UPC-A, UPC-E, EAN-8, EAN-13, Interleaved 2 of 5, Codabar, PDF417, QR Code, Data Matrix
Scanning Method	Thermal Transfer/Direct Thermal
Operating Temperature	41°F to 104°F (5°C to 40°C)
Storage Temperature	-40°F to 140°F (-40°C to 60°C)