TSC AUTO ID Technology Co., Ltd. 5 Copyright 2009 All Rights Reserved.
GAPDETECT
Description
This command feeds the paper through the gap sensor in an effort to determine the paper
and gap sizes, respectively. This command references the user’s approximate measurements.
If the measurements conflict with the actual size, the GAPDETECT command will not work
properly. This calibration method can be applied to the labels with pre-printed logos or texts.
Syntax
GAPDETECT [x, y]
Parameter Description
x Paper length (in dots)
y Gap length (in dots)
Note: If the x, y parameters are ignored then the printer will calibrate and
determine the paper length and gap size automatically.
See Also
GAP, SIZE, BLINEDETECT, AUTODETECT
To Next Page
Loading...