TSC AUTO ID Technology Co., Ltd. 10 Copyright 2009 All Rights Reserved.
OFFSET
Description
This command defines the selective, extra label feeding length each form feed takes, which,
especially in peel-off mode and cutter mode, is used to adjust label stop position, so as for
label to register at proper places for the intended purposes. The printer back tracks the extra
feeding length before the next run of printing.
Syntax
English system (inch)
OFFSET m
Metric system (mm)
OFFSET m mm
Parameter Description
m The offset distance (inch or mm). -1 ≤ m ≤ 1(inch)
CAUTION: Impropriety offset value may cause paper jam.
Example
English system (inch)
OFFSET 0.5
Metric system (mm)
OFFSET 12.7 mm
See Also
SIZE, GAP, SET PEEL, SET CUTTER
To Next Page
Loading...