3-4 Model 3076 Constant Output Atomizer
4. In the recirculation mode, the side opening at the top of the
Atomizer assembly block (side port of the Swagelok tee) is not
used. Be sure to seal it with the Swagelok plug (part no.
1601563) provided.
5. Remove the cap and ferrules from the top opening of the
Swagelok tee at the top of the Atomizer assembly block and put
in the ½-inch Swagelock port connector (part no. 1602153) as
shown in Figure 3-2 to connect to the conductive tubing for
polydisperse aerosol coming out from the Atomizer.
Figure 3-2
Port Connector for Polydisperse Aerosol Outlet
Refer to Chapter 4, “Operating the Atomizer,” for information on
connecting compressed air.
To Next Page
Loading...