Operation 17
When measuring Flow as the Primary measurement, the parameters
can be quickly changed by pressing the or key while on the
main measurement screen:
Make adjustments with the or arrow keys and press to
accept, or enter the Select Duct or Select Kfactor menu to choose a
different pre-programmed flow value or dimension.
The Horn numbers are the models of the horns. For example, 100
refers to a horn model number AM 100. Only horns with Model
numbers as follows can be used with this function: AM 100, AM 300,
AM 600 and AM 1200. If a horn model number is chosen, the
instrument will return to measuring mode and use a preprogrammed
curve to calculate flow rate from velocity when using a
thermoanemometer probe.
The Air cone selection applies to the Model 995 Rotating Vane
Anemometer and the Air Cone kit p/n 801749 which are used to take
flow measurements on small outlets.
VOC SETUP
This menu item applies to TSI probes that measure Volatile Organic
Compounds (VOC). Refer to the manual included with VOC probe
Models 984, 985, 986, and 987 for information on usage and setup.
To Next Page
Loading...
Need help?
General
