Version 1.7 (June 2017)
TSI Flowmeters Ltd.
15
A wide range of adaptors are available that allow
the Flowmaster 250 to work with your pipework
and ttings. The standard tting supplied is to the
internationally recognised 2.5” BSP male thread. Onto
this can be mounted BS Inst. M/F, NH or NST M/F, Storz,
Nor Kuppling, etc.
The ow monitoring system provides a data logging
function on a PC or laptop of the ow rates measured
by the Flowmaster. The ow monitoring system consists
of an RS485 to RS232 converter that interfaces the
ow meter to the PC or laptop, cables and software
to capture and display ow data. Screenshots from PC
software for use with the ow monitoring system are
shown in Figure 6.4.
7
ACCESSORIES
7.1 BALL VALVE WITH BS INST. M/F FITTINGS
The ball valve facilitates speedy and safe static pressure
readings and creates back pressure for taking ow and
residual pressure measurements.
7.2 TRANSPORT & STORAGE CASE
Transport case with castor wheels and extension
handle. Weight 7kg.
Fig. 7.2 Transport case
(Model No. 34-2104)
7.3 ADAPTORS
Fig. 7.3 Selection of adaptors available for use with the
Flowmaster 250
We can also supply to ¾” BSP male, 1” BSP male, 4”
BSP male as standard items. These adaptors are tapered
so as to minimize turbulence and uid restriction,
thereby ensuring minimum interruption to uid ow
and accurate measurements.
7.4 FLOW MONITORING SYSTEM
Fig. 7.4 Data interface and FMS software
7.5 REPLACEMENT BATTERY/MAINS CHARGER
Fig. 7.5 Replacement Battery Pack available
Fig. 7.1 Ball Valve to facilitate static pressure
measurements
Fig. 7.6 Mains Battery Charger available
Fig. 7.7 In-car Charger available
To Next Page
Loading...
