Version 1.7 (June 2017)
TSI Flowmeters Ltd.
TOTALISER FUNCTION3.2
8
1) Press M (mode) switch once, to enter totaliser
mode
2) Display shows total litres own since last reset.
Press M again to re-enter ow measurement mode
3) Re-set totaliser by pressing S and P switches
simultaneously for at least one second and then
releasing
4) Figure displayed will automatically re-set to zero
The ow meter has a built in totalising function. The
volume of water that has passed through the ow
meter is totaled and stored in internal memory.
Put the meter readout into totaliser mode by pressing
the M (mode) switch once.
The volume reading is stored in ash memory and is
does not return to zero even after power is turned off.
Volume accumulates until a manual reset is carried out
as explained in g 3.2.3.
To Next Page
Loading...
