TSI Instruments SMPS 3938 User Manual

Unpacking and Setting Up 2-25
4. Push one end of the 25-inch length onto the Sheath Flow + fitting on
the Long DMA. Push one end of the 12-inch length tubing onto the
Sheath Flow - fitting on the bottom of the Long DMA.
5. Place the base of the Long DMA at an angle over the classifier
mounting plate and snap the Long DMA into place. The curved side of
the LDMA base faces away from the classifier.

TSI Instruments SMPS 3938 Specifications

General

Brand	TSI Instruments
Model	SMPS 3938
Category	Laboratory Equipment
Language	English