TSI Instruments SMPS 3938 User Manual

2-38 Electrostatic Classifier Model 3082 and SMPS Spectrometer Model 3938
Powering On the Classifier
The classifier should be connected to an AC power outlet.
To connect the classifier to a power source, follow these instructions:
1. Plug the supplied power cord into the AC Power In connection on the
back panel of the classifier.
2. Plug the power cord into your electrical supply. It is not necessary to
select the correct voltage; the classifier accepts line voltage of
85 to 260 VAC, 50 to 60 Hz, 200 W max., single phase.
3. Flip the rocker switch on the AC Power In connection. The instrument
powers up automatically.
Note: A “soft” power
button is
provided on the
front panel to
turn the
instrument on
and off. Once
the instrument is
initially switched
on using the
rocker switch,
use the front
power button to
turn on and shut
down the
classifier.

TSI Instruments SMPS 3938 Specifications

General

Brand	TSI Instruments
Model	SMPS 3938
Category	Laboratory Equipment
Language	English