TSi Power Corporation MC80043,4,5,6,7,8,9,50
ATS-800 Series Automatic Transfer Switches Rev. 3, April, 2018
TSi Power Corporation Proprietary Information 16
the circuit breaker trips, even without any load, then there is a faulty component on the board
assembly. The Board assembly must then be repaired at the factory (or replaced in the field).
P/N FC00114-15 A & P/N FC00116-30 A Breaker P/N FC00065-40 A Breaker
P/N FC00115-20 A Breaker
Figure 14: Primary & Backup Type AC Input Two-Pole Circuit Breakers-15, 20, 30 & 40 A
2.4 AUDIBLE ALARM SWITCH (See Figure 15)
Figure 15: P/N SE00002 Audible Alarm On/Off Switch
3. INSTALLATION
3.1 SITE SELECTION & PREPARATION
• This product is intended for installation in “A PROTECTED ENVIRONMENT
ONLY”.
• The ATS Series is designed to be mounted in a rack.
• Note the following if an ATS without internal circuit breakers is being installed;
- For permanently connected equipment, a readily accessible disconnect device
shall be incorporated external to the equipment.
To Next Page
Loading...