Setting up the Edge via Detection Management Software 3-13
Figure 3-10
Edge Security Setting Screen
Auto Run Setting
With the Edge auto run setting, you may program up to two auto start
and auto stop configurations when start date and duration parameters
are enabled. This may be useful if you want to pre-set the instruments to
run and stop for a specific time period, such as a week-long study. See
steps below to enable.
1. Click on the Auto Run tab from the Edge’s Instrument Configuration
panel (see 1) and click in the Enable auto run mode checkbox
(see 2).
2. To program Date 1, click in the Enabled checkbox and select a Start
Date (by using the calendar icon or type in a date). Select the
Duration, by either typing in the time (designated in hours, minutes,
and seconds) or using the up/down arrows (see 3). (Repeat this step
to setup a second Auto run mode, except select Date 2. See 4.)
3. Click the button to set the auto run setting (for more
details, see “Saving and Sending/Setting Configurations”).
On the Edge, Power Off the instrument when the configuration is set in
order to auto-start the instrument.
To Next Page
Loading...
Need help?
General
