V1.0
·Choose the installation location carefully and adhere to specified cooling requirements.
Micro-inverter should be installed in a suitable position with good ventilation and no direct
sunshine.
·There are no screws and nuts in the package.
·The distance between every two micro-inverters should meet the length of AC cables. The
length of the AC cables is shown below:
TSOL-MS800/MS700/MS600
TSOL-MS600-D/MS700-D/MS800-D
TSOL-MS1600/MS1800/MS2000/MS2000
（
1500
）
·Please use your mobile phone to check the WiFi signal strength at the installation location,
ensuring that the WiFi signal is at least two bars. If the WiFi signal is not good, please try
installing the mini inverter in another location or moving the WiFi router.
Tip: A space of 5cm needs to be left between the microinverter and the roof to ensure its heat
dissipation.
Choose the best installation position. Use two pairs of screws and nuts to fix the microinverter on the
frame. Make sure that the label of the microinverter should be the upside.
To Next Page
Loading...
