TuffStuff TS-1000 - Safety Precautions; General Safety Guidelines; Pin Engagement Check

Fig. 2 Caution: Check that the two Push Pull Pins 1/2 X 3-1/2 (#5
6
located on the Press Bar Selector Housing (#23), and the High-Lo
w
Carriage (#14), also the Push Pull Pins 1/2 X 5-5/8 (#58) located on t
h
and the Front Upright (#6) are fully engaged into the selected holes of t
h
Press Bar (#23), High-Low Selectorized Upright (#13), and the Ba
c
Pad Bracket (#7).
S
afety First
R
egardless of how enthusiastic you may be about getting on
y
our equipment and exercising, take the time to ensure that
y
our safety is not jeopardized. A moment’s lack of attention
c
an result in an accident, as can failure to observe certain
s
imple safety precautions.
1
. Read, study and understand the Owner’s Manual and all
the warning labels on this product. Furthermore, it is
recommended to familiarize yourself and others with the
proper operation and workout recommendations for this
Tuff Stuff product prior to use. Some of this information
can be obtained in this Owner’s Manual, as-well-as from
your local Tuff Stuff retailer.
2
. It is imperative that you retain this Owner’s Manual and be
sure all warning labels are legible and intact.
Replacement Owner’s Manuals and labels are available
from your local Tuff Stuff retailer.
3
. Consult with your physician before beginning any exercise
program.
4
. Use proper discretion when children are present.
5. Frayed or worn cables can be dangerous and may caus
e
injury. Periodically check these cables for any indicatio
n
of wear.
6. Keep hands, limbs, loose clothing and long hair well out o
f
the way of moving parts.
7. Do not attempt to lift more weight than you can contr
o
safely.
8. Inspect the Unit for any sign of wear on parts, hardwar
e
becoming loose or cracks on welds. If a problem is foun
d
do not use or allow the machine to be used until th
e
defective part is repaired or replaced.
9. Pay special attention to the Push Pull Pins 1/2 X 3-1/
2
(#56) located on the Press Bar Selector Housing (#23)
and the High-Low Carriage (#14), the Push Pull Pins 1/
2
X5-5/8 (#58) located on the and the Front Upright (#6)
also the Turn/Pull Pin w/Knob (#57) located on the Le
g
Extension Bench Frame (#9). See Fig.1. Be sure the
y
are fully engaged into the selected holes. Refer to Fig. 2
3 for further illustration of this instruction.
Safety Precautions
ig. 1 Illustration above depicts the location of the Push Pull Pins 1/2” X
-
1/2 (#56), Push Pull Pins 1/2” X 5-5/8 (#58), and the Turn/Pull Pin w/
K
nob (#57) on this unit.
T
urn/Pull Pin
w
/Knob (#57)
Push Pull Pin
1/2 X 5-5/8 (#58)
Turn/Pull Pin w/Knob
Fully Engaged
Fig. 3 Caution: Check the Turn/Pull Pin w/Knob (#57) to be ful
l
engaged into the selected hole of the Adjustable Seat Frame (#37).
Push Pull Pin
1/2 X 3-1/2
Fully Engaged
P
ush Pull Pin
1
/2 X 3-1/2 (#56)
Push Pull Pin
1/2 X 3-1/2 (#56)
T
S-1000 Home Gym w/Adjustable High-Low Pulley System 2
CAUTION
CAUTION