turbocut Blitz Kerner - First Use; Checking the Device

10 Captive bolt stunner device
5. First use
The blank cartridges should be stored in a dry location and protected from
unauthorized use and manipulation. They must be protected from heat and
kept away from naked ames and other ignition sources.
Do not store them together with ammable or other materials that increase
the likelihood of hazards. The national legal provisions are to be observed.
The blank cartridges should be stored exclusively in the original manufac-
turer's packaging.
5.1 Checking device
Storage temperature Recommended storage temperature Relative humidity
0°C up to +30°C +20°C max. 60%
The Regulation on the protection of animals at the time of killing stipulates that
the correct function of the captive bolt stunner must be checked at least once
before the start of work every day.
Recommended before and aer each use!
Ensure that there is no blank cartridge in the cartridge receiver. The active
parts must exhibit no corrosion!
Check the position of the bolt. To do so, hold the device vertically with the
exit opening pointing downwards. The bolt must be at least 4 mm inside
the sleeve and must hold itself in place there (see chapter 7 – Troubleshoo-
ting).
Should the bolt stand back less than indicated or even be ush or protrude
from the sleeve, the bolt cannot be freely accelerated. In this case, the bolt
spring and the rubber buer must be replaced.
Check the rubber buer and the bolt spring for wear before use. The lock
must be screwed in ush with the sleeve.
Never use the device without a rubber buer or a bolt spring!
Storage
The captive bolt stunner can be guaranteed to operate properly if blank
cartridges and spare parts that are tested and approved by us are used in
their original condition.