turbocut Blitz Kerner - Manufacturer Warranty

23
Captive bolt stunner device
12. Warranty
turbocut Jopp GmbH warrants that its captive bolt stunners are free of ma-
terial and manufacturing defects. This warranty applies with the prerequi-
site that the device be properly used, handled, cared for and cleaned in
accordance with these operating instructions and that it be maintained as
a technical unit.
This means that only original consumables, accessories and spare parts or
other products of equivalent quality are to be used with the captive bolt
stunner.
This warranty encompasses repair or replacement of defective parts free of
charge throughout the entire service life of the device. Parts that are sub-
ject to normal wear, for example the rubber buer and the bolt spring, are
not covered by this warranty.
Further claims are excluded insofar as this does not contravene any man-
datory national or international regulations. In particular, turbocut Jopp
GmbH shall not be liable for direct or indirect defects or consequences of
defects, losses or costs in conjunction with the use of the captive bolt stun-
ner for any purpose whatsoever. Implied assurance for the use or suitability
for a particular purpose is expressly excluded.
The captive bolt stunner and/or aected parts must be returned to the ma-
nufacturer or their appointed representative for repair or replacement im-
mediately aer discovery of a defect.
This warranty declaration encompasses all warranty obligations on the part
of turbocut Jopp GmbH for the Blitz captive bolt stunner and replaces all
earlier or simultaneous declarations, written or verbal agreements with re-
gard to warranty services.
The Blitz captive bolt stunner apparatuses from turbocut Jopp GmbH are
type-approved and system-tested. For this reason, the device is furnished
with a PTB approval number and is registered with the above-named aut-
hority under: DE-17-MARLIV18-PTB01.
With this, turbocut Jopp GmbH guarantees the compliance of each captive
bolt stunner with the approved design.
Any unacceptable defects discovered during use must be reported immedi-
ately to the manufacturer or his authorised representative.
C.I.P. Test conrmation